APC Back-UPS 1200VA, 230V, AVR, Schuko sockets

A backup power supply with surge protection for computers and electronic devices

• Automatic voltage regulation: Raises low voltages and lowers high voltages to levels suitable for your equipment automatically.
• Protection of connected equipment against data line surges
• Indicators that allow easy reading of the status of the mains power, UPS and battery.
• PowerChute Personal Edition Operating System Compatibility: This software supports many operating systems and processors
• Battery and Surge Protected Outputs Only: Reserves power capacity and uptime for connected equipment that requires battery backup, while limiting surge protection for less critical equipment
• Status Light Display: Quickly identify unit and power status with visual indicators.
• Audible alarms: Notify of changing mains and UPS conditions.
• Intelligent battery management: Maximises battery performance, life and reliability through an intelligent precision charging process.
• Battery Failure Notification: Provides battery failure analysis with early warning, enabling timely preventive maintenance
• Automatic self-test: Battery self-test is performed periodically to ensure early detection of the need for battery replacement.
• Safety Board Approved: Ensures that the product has been tested and approved as safe to operate with the connected loads and within the environment.
• Surge Protected Battery and Outlets: Back up and protect your equipment and data in the event of power outages, surges or spikes.
• Surge outlets only: Protect your secondary electronics from power surges and spikes, without diminishing the battery power used to operate primary electronics during a power outage.

• Line-interactive UPS
• Output power capacity: 650Watts / 1200 VA
• Output connections: (4) Schuko sockets (Battery back-up)
• Nominal output voltage: 230V
• Nominal Input Voltage: 230V
• Input connection type: CEE7 male
• Cord Length: 1.2 metres
• Output frequency (mains sync): 50/60 Hz +/- 1 Hz Sync to mains
• Waveform type: Approximate sine wave
• Transfer time : 6 ms typical (10 ms maximum)
• Input frequency: 50/60 Hz +/- 5 Hz
• Input voltage range for mains connection: 140 - 300V
• Input power factor at full load: 0.63
• Battery type: Sealed lead acid battery
• Typical recharge time: 8 hour(s)
• Expected battery life (years): 1 - 2
• Interface Port(s): USB
• Control Panel: On-line or battery status indicator
• Audible alarm: Alarm when switching to battery mode; separate low battery alarm
• Over-current energy rating: 273Joules
• 10/100/1000 Base-T RJ45 Ethernet protection
• Audible noise at 1 metre from the surface of the unit: 40.0dBA
• Protection class: IP20
• Dimensions : W x H x D): 140 x 190 x 390 mm
• Net weight: 7.6 kg
• Colour: Black
• Standard warranty: 2 years, repair or replacement