Received
Good box, very nice, nice finish, but I had a lot of problems.
To use the vertical graphics card slot, you have to remove 2 slats, these 2 slats are part of the case's shell and are held in place by micro-junctions.
Once removed, it is impossible to reassemble them. If you don't want to use this place anymore (or you can't) you'll find a big hole behind. (Not all risers are compatible because of the proximity of the power supply cover)
There really isn't much room for the power supply cables. I wanted to remove the HDD rack to make it easier to plug in my modular power supply but I couldn't remove it because of a screw that is too tight and I broke the crosshatch... I'm not sure if I'm going to be able to do this, but I'm sure I'll be able to do it again.
I don't know if it's normal, but one of the four screws in the glass is smaller than the others. It doesn't fit on any hole, otherwise you screw in the void.
There is a hole where you screw into the void whatever the screw is but it holds well.
There are 4 vertical ssd slots, 2 of which have black covers. I'm not sure if it's a good idea to use a black cover or not, but it's a good idea to use a black cover.
The top filter is fixed by magnet. I'm not sure if it's a good idea to have a filter on the top of my PC, but my 18 month old daughter quickly realized that the filter can easily get out of place.
The front filter is also fixed by magnet, but small round magnets that are embedded or glued on the filter, except that some magnets move freely. The result is that when I remove the filter, 3 out of 4 magnets remain on the case and if I had not seen them by chance I could have lost them, or worse my daughter could have found them and swallowed them.
