Pictures may differ from actual products
Thermal Grizzly's liquid metal thermal paddleConductonaut has been developed for high efficiency uses. It is the top of the range product for experienced users who are looking for the best heat dissipation solution.
Thermal Pte (5 grams)
Select your criteria
General information |
Product name |
Thermal Grizzly Conductonaut (5 grams) |
Brand |
Thermal Grizzly | |
Model |
TG-C-005-R | |
Technical specifications |
Thermal paste capacity |
5 g |
Thermal conductivity in W/mk |
73 | |
Warranties |
Legal warranty |
See terms & conditions |
Product referenced on 29 Mar 2017
The paste is actually very liquid, very close to mercury. Difficult to dose (I pressed very hard and it came out very quickly). The quality of the product is there with a process that remains fresh even when pushed to 5Mhz
Very surprising, application more complex than standard paste, do not hesitate to protect the components with nail polish.
Tested on an old M6500 laptop, whose processor does not have a capsule, I went from 55° to 35°, but to remain constant the ventilation must be permanent. In the case of the M6500, the fan starts at 60° and 2600 rpm. as soon as the fan is running, it immediately goes back down to 35°. I tested with OCCT over 3 hours, no worries, max temp of 65°.
Also tested on a Bi-Xeon Paxville (first dual cores).
Without delid, representative gain of 20°, from 60° to 40°, much less noise, delta fans spin much slower. OCCT 3 hours temp max 66°, so all good.
I think that this paste should be reserved for delid, between the capsule and the rad or aio, it does not always work or gives very bad results (bad contact between cpu and RAD. in this case I recommend Grizzly Kryonaut. you will easily gain a dozen degrees
Here is my configuration: I5 6600K oc 4,5 Ghz 86 ° in full (1h OCCT) with watercooling before applying the thermal paste.
After decapsulating the CPU to replace with conductonaut and replacing the artic silver 5 between the CPU and the waterblock my temperature reaches 69 ° in full (1h OCCT).
Being in limit of tension 1,35 volt, I did not push more my overcloking, on the other hand with a so low temperature, I do not hear any more my fans and there it is happiness!
As for the application of the paste, it's not very easy, a slightly larger and transparent tube would allow to easily suck the excess of paste (half a star less for this point).
In the same universe: thermal grizzly
